Rubber extruder production capacity
Release time:
2024-01-10 10:19
The relationship between the production capacity of the rubber extruder screw speed means that as the screw speed increases, the production capacity increases, but the screw speed of the plastic extruder is too high, the production capacity is not high, and the rubber is easy to burn.
The relationship between the production capacity of the rubber extruder and the screw speed is that with the increase of the screw speed, the production capacity increases, but the screw speed of the rubber extruder is too high, the production capacity is not large, and the rubber is easy to burn; and the screw speed The relationship is that as the screw speed increases, the power also increases, but as the screw speed of the plastic extruder increases, the power gradually decreases. The relationship between the head pressure and the screw speed of the rubber extruder is that as the screw speed increases, the head pressure also increases. Rubber and cylinder: the relationship between the speed and the shearing, kneading, plasticizing and heating of the rubber in the cylinder.
The inner surface hardness of the rubber extruder barrel is higher than the inner surface hardness of the plastic extruder screw, and its damage is later than the inner surface hardness of the plastic extruder screw. The scrap of the rubber extruder barrel is due to the increase in the inner diameter due to time wear. If there is a nitrided layer on the barrel of the rubber extruder, the inner hole of the rubber extruder can be directly drilled and ground to a new diameter size, and then a new extruder screw can be prepared according to this diameter.
The inner diameter of the rubber extruder barrel is machined, and then the alloy with a thickness of 1~2mm is cast, and then refined into a certain size. Under normal conditions, the homogeneous section of the rubber extruder barrel will wear out quickly, and the nitrided alloy steel bushing can be used for boring and trimming. The diameter of the bore in the barrel of the plastic extruder refers to the screw diameter of the extruder. The rubber extruder barrel and rubber extruder screw can be left in the normal gap suitable for processing and processing.
preceding one: Application of Computer Integrated Manufacturing System for Rubber Machinery
the next one: Selection of Rubber Extruder